Skylight initialization sunroof initialization steps are as follows:
    1) Make sure the skylight is closed. Such as the sunroof by normal switch action can not be closed,
    You can use the electric force to close (when the sunroof switch is in the closed position press the switch with the marked end and hold) or mechanical forced to close (with a decorative cover on the handle shake the sunroof motor off the skylight);
    2) Turn on the ignition switch to ensure that the sunroof switch is in the closed position;
    3) Remove the skylight motor trim panel;
    4) unplug the sunroof motor plug, wait 10s after re-plug;
    5) Rotate the sunroof switch to the open direction 90 degrees quickly to return to the original position (from opening to return to the original position must be completed within half a second). At this point you can hear the motor has a loud voice, and you can see the motor shaft slightly turn a bit, immediately press the skylight switch with the mark side and keep until the skylight to open, close, upturn, back a set of cycles In order to release the sunroof switch, so that the skylight to complete the re-memory. Note: the skylight in the initialization process without anti-folder function, do not hand into the open skylight;
    6) The above steps in the skylight of a set of cycles failed to perform, re-do 3,4,5 step;
    7) Check the skylight function according to the normal working conditions.
    Skylight initialization steps are as follows:
    1) Make sure the skylight is closed. Such as the sunroof by normal switch action can not be closed,
    You can use the electric force to close (when the sunroof switch is in the closed position press the switch with the marked end and hold) or mechanical forced to close (with a decorative cover on the handle shake the sunroof motor off the skylight);
    2) Turn on the ignition switch to ensure that the sunroof switch is in the closed position;
    3) Remove the skylight motor trim panel;
    4) unplug the sunroof motor plug, wait 10s after re-plug;
    5) Rotate the sunroof switch to the open direction 90 degrees quickly to return to the original position (from opening to return to the original position must be completed within half a second). At this point you can hear the motor has a loud voice, and you can see the motor shaft slightly turn a bit, immediately press the skylight switch with the mark side and keep until the skylight to open, close, upturn, back a set of cycles In order to release the sunroof switch, so that the skylight to complete the re-memory. Note: the skylight in the initialization process without anti-folder function, do not hand into the open skylight;
    6) The above steps in the skylight of a set of cycles failed to perform, re-do 3,4,5 step;
    7) Check the skylight function according to the normal working conditions.