When you buy a new Mercedes-Benz sedan, you should read the instructions carefully in the first step, which will make you feel comfortable when driving this new car.
    Here we summarize some of the new car running and the use of common sense:
    1, when you buy a new car to the brakes, throttle, steering angle, lighting use, sound use, etc., in the driving when the operating items must be familiar with the use, so as not to cause unnecessary trouble in the traffic.
    2, in your new car before driving 1500 km should be careful to operate the car's engine, so that the engine in the future for a long time to play the best performance.
    3, in accordance with the driving conditions to adjust the speed and engine speed, but can not make the engine overload (unreservedly accelerated), to avoid the engine speed is too high (speed can not exceed any speed limit speed 2/3). If necessary, do not step on the accelerator pedal to the overspeed switch to allow the gearbox to be forced into a low gear. Manual transmission of vehicles in the appropriate time shift, do not change the use of low-speed engine braking performance to enhance the braking effect. 3, 2 or 1 block can only be used when the speed is slow, such as climbing slope.
    4, after driving over 1,500 km, you can gradually increase to full speed and engine speed. In the service station should be purchased at the service station to add the original fuel additives, added in the way to refuel, can effectively avoid the fuel quality is not good, to avoid the vehicle engine work, resulting in unnecessary damage.
    5, in the 5000-8000 km to the Mercedes-Benz repair service center to do the first security, according to China's national conditions in the instrument will be prompted to 8,000 km maintenance, every 20,000 - 30,000 km to do an engine cleaning, including the inlet , Throttle, fuel injection head, gasoline pipeline, engine computer inspection and setting. By cleaning the vehicle for a long time to keep the engine power.
    6, the driver in the driving process, do not put your hand hanging on the bar, so easy to appear in the inadvertently when the gear becomes low when the speed can not rise. There is also a situation that will make the vehicle suddenly unable to drive on the speed, which is when you hit the direction may encounter the speed limit lever, causing the vehicle speed at a certain set speed.
    7, in the vehicle equipped with SBC brake system, you must grasp the brakes and throttle, because its braking system is computer control, and the general brake system is not the same. So do not get used to feel the vehicle is not soft, the use of heavy step on the throttle to make the performance of the vehicle to play out.
    8, in a four-wheel drive with a long time not to use four-wheel drive low-speed block, so that the engine and gearbox caused premature wear and tear, thus affecting vehicle performance.
    9, vehicle tires to always check the pressure and tread wear, so you can reduce the high-speed running puncture phenomenon and running deviation situation. Do not rush through the pit quickly. In the upper step on the road should be slowly refueling, so that the tires climb the steps, do not make the tire and the front of the direct contact, so most likely to damage the tires and rims.
    10, in the winter to pay attention to the concentration of glass water should not be too thin, because the existing Mercedes-Benz cars are equipped with headlight cleaning function. If the concentration is not enough to build a car cleaning system frozen, causing damage to some components, headlamps cleaning function is lost.
    11, the vehicle should not be stored for a long time, this will cause the battery charge is insufficient or no electricity, when you use the vehicle can not start normally. If the vehicle is mainly used for short journeys or long time by car idle, should be more frequent check the battery charge situation. If you do not use the vehicle for a long time, please remove the battery battery negative pole from the battery wiring pole, and then use the vehicle before the installation can be.
    Regular and proper maintenance can maintain the value of the vehicle. The most effective way to protect a vehicle from environmental damage is to clean and carry out protective treatment on a regular basis.