At present, the BMW car used in the control of the remote control is divided into two categories, one for the independent launch remote control, and the other for the key integrated remote control, the anti-theft cancellation procedures: Related Reading: BMW car engine Idle operation unstable BMW 135i play face street version of "the other half of the dark"
    (1) If you want to deal with the vehicle is the owner of the use of travel computer to set their own anti-theft password BMW car, and do not know the anti-theft password, you can use the following methods to force the lifting of the program:
    ① Remove the battery wiring of the BMW car and then replace it again.
    ② Open the door on the side of the driver and turn the ignition switch to ON (R or 15 position).
    ③ wait 15min, you can automatically lift the anti-theft password.
    If the trip computer due to failure caused by anti-theft lock, can not be lifted, you can use the following methods to lift:
    Method 1: 55 feet digital engine control computer (DME) 38 # anti-theft line removed, you can lift. Method 2: the 88-pin digital engine control computer (DME) 81 # anti-theft line removed, you can lift.
    Method 3: the BMW Department of the 7 series 6-cylinder, 8-cylinder models of 88 feet of digital engine control computer (DME) 66 # anti-theft line removed, you can lift. (2) If the BMW original configuration remote control vehicle, as long as the remote control on the UNLOCK door key, or use the key to open the door from the driver side, you can automatically lift the anti-theft.
    BMW models anti-theft remote control program is:
    If the car uses a single key and 3 key remote control, and because the battery is not power and other reasons caused by remote control failure, you must re-set the program:
    ① with a small cross hair to open the remote control back cover.
    ② remove the small chip behind.
    ③ find remote control receiver computer (usually located below the instrument panel, or left and right side seats).
    ④ Open the remote cover on the remote control receiver computer and place the wafer removed in step ②.
    ⑤ If the remote control receiver computer has a RESET button, press the key. If you do not have the RESET button, turn the ignition switch to the ON position (R or 15) and turn it back to the OFF position to complete the reset.
    BMW car if you are using a three-button D-type remote control, the reset program is:
    ① Turn on the ignition switch. ② the remote control near the receiver, the closer the better.
    ③ Press the remote control and UNLOCK button until the LED starts flashing, indicating that the program is set up.
    ④ The program is activated after 15s time, you can continue to re-set other remote control, but can only set up to 4 remote control.
    If you are using the remote control with the key (respectively, double button and 3 button), the setting procedures are: double button remote control (key are UNLOCK key and DOUBLELOCK key):
    ① all the doors are closed, the central lock do not press.
    ② turn the ignition switch to ON position, in 5s and then back to the OFF position.
    ③ Press the UNLOCK / LOCK key and press the DOUBLELOCK key three times within 10s.
    ④ release UNLOCK / LOCK button, then the key on the LED lights will flash 10 times.
    ⑤ remote control near the receiver (rear-view mirror), press the UNLOCK / LOCK button or DOUBULOCK button.
    ⑥ At this time the door lock will automatically lock and then open once, that the completion of re-set.
    ⑦ repeat steps ③-⑥, you can set the other remote control, but must be completed within 15min, while a maximum of up to three remote control can be set. BMW car is equipped with three key-type remote control, the anti-theft cancellation procedures:
    ① close the door, the central lock do not press.
    ② turn the ignition switch to the ON position, within 5s and then turn back to the OFF position.
    ③ Press the down arrow key on the key and press the LOCK key three times within 10s.
    ④ release the down arrow key, then the LED will flash, while the central lock will automatically lock and then open, that is completed.
    ⑤ Repeat steps ③-④, you can set the other remote control, within 30s, you can reset up to 3 remote control. If you have previously locked the door or luggage compartment mechanically with a key, you must first open the door or luggage compartment with a key before you can reset the program.