The braking system is critical to the safety of the driver, and once the braking system fails during driving, it often results in a major traffic accident. So the owner should pay attention to learning the braking system of routine maintenance and troubleshooting methods.
    Regular inspection, replacement of brake fluid clean, high-quality brake fluid brake system to maintain a good condition of the basic conditions. Monthly should regularly check the brake fluid level, if the brake surface appears to be significantly decreased, you should go to 4S shop to check. In addition, the purity of the brake fluid is higher, if it is contaminated by impurities or mixed into the air, will seriously affect the braking effect, found that the brake fluid pollution should be put the remaining liquid and rinse the entire system, and then filled with new liquid main tank. The color of the brake fluid will also warn you. If the brake fluid color is too deep, a malfunction may occur.
    Step on the brakes should be checked brake pads and brake disc vehicles, especially when the new car brakes when the body shake, often caused by brake pads or brake disc deformation. If the replacement of the brake pads and brake discs, the fault is temporarily excluded; one or two months later, the fault occurs again, then the side of the hub should be checked, the hub deformation can also cause braking when the jitter.
    Winter car wash after the hand brake hand brake hand brake principle is to pull the hand brake lever with the power, through the brake line to its force to the rear wheel brake system. After the winter car wash, the water may enter the brake line, in the state of the water pull on the hand brake, and after a long stop after the water will freeze, this time, even if the brake lever back, the brake line will not move The So, after the winter car wash, the car should be driving a distance, and then stop the hand brake.